42
43
44
45
17/20
With a straight edge, mark where the
seals will be trimmed at the top and
where to cut the notch around the
bo�om door seal.
Remove the seals and trim with a fine
toothed junior hacksaw so they are
flush with the tops of the panels.
Replace the seals.
A�ach the bo�om door seal so the
deflector fin is on the inside.
Check orienta�on below.
Check the glass to wall seal orienta�on
and trim a notch to fit around the
bo�om door seal.
Trim the flaps
With a sharp modelling knife, cut the
glass to wall seal tail above and below
the 90° glass to wall hinges as shown.
Take care to get these cuts as close to
the hinges as possible to allow the seal
to flex around the hinge without
leaking.
Cut
Cut
VIEW 07
07/2019 V 2.2
