Using a spirit level, align the return
panel so it is ver�cal.
Check the top of the panel is level. This
can be achieved by adjus�ng the
spacers.
Remember not to stack higher than
5mm. If the distance is greater than
5mm, it may be necessary to adjust the
first stack of spacers.
Place spacers into the front
underframe. Begin with 4mm spacers.
NOTE: There must always be a
minimum set of 1mm spacers under
the glass panels.
9
10
11
12
Align the return panel so it bu�s
up against the front underframe
without any gaps.
Carefully place the inline panel onto
the spacers and bu� up against the
return panel. Check the panel is the
correct orienta�on.
Check that the top of the panels are
level. Remember not to stack higher
than 5mm.
03/20
No Gap
4mm
4mm
VIEW 07
07/2019 V 2.2