Insert the square alignment jig to
locate the wall channel. Using a spirit
level, ensure the wall channel is
ver�cal.
Mark the pre-drilled holes.
Using purpose made “Glass Li�ers”,
squarely insert the return panel into
the wall channel and lower onto the
spacers. Take great care NOT to knock
the corners as this can cause the panel
to sha�er.
5
6
7
8
Remove the channel.
Using a 6mm high quality drill bit for a
clean and precise hole, drill the marked
areas, fully insert the wall plugs and fix
the channel.
WARNING
The glass is heavy and may
damage the floor or underframe if
handled incorrectly. It is advisable
to use a suitable non-slip
protective mat or piece of carpet.
Never rest the glass across the
underframe as this may cause
damage.
Professional Tip
If drilling ceramic tiles, place
masking tape on the tiles before
marking and drill through the
tape to prevent the drill bit from
skidding.
DO NOT use Hammer Action as
this will break the tiles.
Place spacers into the underframe
evenly, as shown below. Begin with the
4mm spacers.
NOTE: There must always be a
minimum set of 1mm spacers used
under the glass panel.
02/20
4mm
4mm
VIEW 07
07/2019 V 2.2
