V2.1
–
TH3D EZABL
™
Pro Installation Guide -
Copyright © 2021 TH3D Studio LLC
–
ALL RIGHTS RESERVED
6
Mounting the sensor
Once you have the new mounts you will need to install them on your hotend and then mount
the sensor to the new printed mount.
When you mount the sensor, it should be about 2mm
ABOVE the tip of the nozzle for both sensor sizes.
This does not have to be exact just higher
than the nozzle but not too high. Most of the flat wrenches included with the printers are about
2mm in height and can be used to set the sensor height.
If you are using the EZABL
™
Mini size sensor and using the standard 18mm sensor mount use
the included adapter rings to center the EZABL
™
Mini in the 18mm mounting hole. The smaller
side should be inside the ring of the 18mm hole to center the probe.
Once mounted make sure the nuts are tight and you check them from time to time.
If the nuts
loosen the sensor will not work reliably. You can use Loctite (blue preferred) to keep them in
place if this happens to your setup frequently.
2MM higher than nozzle.
