V2.1
–
TH3D EZABL
™
Pro Installation Guide -
Copyright © 2021 TH3D Studio LLC
–
ALL RIGHTS RESERVED
18
Updating your Slicer
Update your 1
st
Layer settings -
To get the best 1
st
layer and adhesion we recommend the
following settings:
•
150% 1
st
layer width
•
0.3mm 1
st
layer height
•
Print SLOW 25-30% speed or 20mm/s
•
Use a skirt set 2-3mm from the part with 2-3 outlines. Use this to adjust/check the
leveling result.
o
Use the Babystepping feature mentioned on the previous page to live adjust
your Z height.
•
DO NOT TURN ON ANY SETTINGS IN YOUR SLICER TO MAKE THE HOME POSITION THE
CENTER OF THE BED. Your X0 Y0 position is still the same as it was before the upgrade,
which is the front-left corner of the bed.
Update your starting Gcode
•
Open the
“EZABL Starting Gcode V2.txt” file located in the Installation Guides folder.
•
Copy the entire file contents and paste it into the starting code/scripts section of your
slicer replacing the existing code
The new gcode will have a 10 second wait for heaters to recover after probing. If 10 seconds is
not enough to let your heaters recover change the S10 in the starting code above to however
many seconds you want to wait for the heaters to recover.
Get into the habit of leaving your sensor homed BEFORE you start a print this will ensure that
the bed is in the same state as when the sensor was calibrated.
Your bed will warp/flex during each heating cycle and this minimizes getting an inaccurate
mesh when the sensor takes its readings.
You can now run your first print!
Slice up your favorite test file (ours is the
) and print!
Make sure to check the skirt and use the Babystepping feature to fine-tune your
first layer. If you made any adjustments be sure to store them using Control>Store
Settings.
