V2.1
–
TH3D EZABL
™
Pro Installation Guide -
Copyright © 2021 TH3D Studio LLC
–
ALL RIGHTS RESERVED
8
Directly Wiring Power
If you are wiring to your printer power supply, make sure that you match the positive and
negative
connections on the power supply and EZABL™ Pro Control
Board DC Power Input
Terminal. DO NOT connect to the AC lines.
The supplied wire has a red wire and a black wire contained inside the outer sheathing. Strip
this back at both ends and then strip the black and red wires at each end as well.
Positive is labeled with + on our board and usually is V+ on your power supply. Use the red wire
for this connection.
Negative is labeled with
–
on our board and usually is V- on your power supply. Use the black
wire for this connection.
Use the included screwdriver to secure the wires in the terminal, do NOT over tighten.
If in doubt sent a picture of the wiring to our support BEFORE you power the machine on and
we will verify proper connection
