TGB Hornet 50, Service Manual

Page: 63 / 86

63
4-3-3 Assembly of Engine:
5. Assembly of Oil-Pump:
A. Apply a layer of grease (GA50400005) on the sliding part and
gear tooth of oil-pump driven gear (1) and then insert into the crank case.
B. Install the oil-pump (2).
6. Assembly of Reed Valve:
A. Install the reed valve (5) on the in-take pipe.
B. Install the gasket (6) and the in-take pipe (4) into the crank case.
C. Screw the fender bracket (7) on the in-take pipe.
7. Assembly of Starter Motor:
A. Apply a thin layer of grease (GA50400004) on the shaft of
pinion gear assy and then install into the crank case.
B. Install two knock-pins (9).
C. Install starter idle gear cap (10) and screw (3)