Scrap Alarm
As the machine runs, the scrap spool cycles on and off rolling up the scrap stream. This is done by
running the spool until the dancer arm hits the switch, which stops the spool allowing the arm to drop
again. If the switch is not made in the time allowed in this screen then the machine will alarm and stop.
This is so that any break in the scrap stream will not continue for an extended amount of time causing bad
packaging and a mess.
Press the RAISE or LOWER button to adjust the value, or type in a desired setting. When done press
ENTER.
To return to the previous screen press the EXIT button. To return HOME, press the button directly below
the label HOME.
20
