Textron PT-3500, Operator'S Manual

Page: 116 / 136

Revolution Series PT-3500 / PT-7500 Puller Tensioner Page 108
Maintenance
Pre-Operation Inspection Checklist
(Page 2)
6.
Inspect hydraulic pump and hoses for loose fittings, leaking fluid, and damaged hoses .
7.
Inspect for structural damage , bent or broken parts, cracked or broken welds, missing
pins and retainers.
8.
Inspect drive motor(s), drive shaft/shaft cones/bar/pin, and screws on reel shaft coupling
to ensure they are secure and that there are no obvious signs of damage- if damaged do not
operate, service may be required. For the PT-3500, also inspect the pillow block bearing and
fasteners.
9.
Inspect levelwind for any obvious signs of damage, leaking
hydraulic cylinders or hoses, and ensure
rollers move freely.
10.
Inspect all equipment grounds for any signs of
damage.
11.
Inspect all jacks for damage or leaking hydraulic components.
12.
Conduct towing readiness inspection.
a. Inspect trailer hook up, and ensure that hitch is secure, safety
chains are in place (crisscross pattern), and trailer lighting is
connected.
i. Inspect tail lights to ensure all lights work- replace bulbs
as needed. If none of the lights work, inspect vehicle
fuses, then trailer wiring for corrosion.
ii. Ensure that trailer brakes work and that wheel chocks are available.
b. Check tire pressure- tire pressure should be checked cold and read:
[PT-7500: 110 psi cold ] / [ PT-3500: 125 psi cold] .
i. If tire pressure is low, inspect tire for damage or punctures. If
damaged or punctured, have repaired or replace.