50
7. Apply oil to the new filter O-ring
and check to make sure it is posi-
tioned correctly; then install the new
oil filter. Tighten securely.
8. Install the oil filter drain plug and
tighten securely.
9. Install the engine drain plug and
tighten it securely. Pour ACX All-
Weather Synthetic oil in the filler
hole. Install filler plug.
10. Start the engine (while the ATV is
outside on level ground) and allow it
to idle for a few minutes.
11. Turn the engine off and wait approx-
imately one minute. Recheck the oil
level.
12. Inspect the area around the drain
plug and oil filter for leaks.
Front Differential and Rear
Drive Gear Lubricant
(Inspecting/Changing)
Inspect and change the gear lubricant in
each according to the Maintenance
Schedule. When changing the lubricant,
use approved SAE 80W-90 hypoid oil
and use the following procedure.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by
removing in turn the drain plug from
each.
CF107B
CF106C
4. After all the oil has been drained,
install the drain plugs and tighten
securely.
5. Pour recommended oil into each
filler hole.
NOTE: If the gear case has a level
plug, fill to the threads of the level
plug. If the gear case has only a fill
plug, fill to within 1 in. of the threads
of the fill plug.
CF113A
CF116A
NOTE: The manufacturer recom-
mends the use of genuine lubri-
cants.
6. Install the filler plugs and level
plugs.
CAUTION
Inspect the oil for any signs of metal
filings or water. If found, take the ATV
to an authorized dealer for servicing.
CF113A
