41
To either engage or disengage the front
wheels, move the switch to the 4WD
position or to the 2WD position.
Reverse Override Switch
This ATV is equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override switch.
Throttle Lever
XR186A
Control engine RPM with the position of
the throttle lever. Operate this lever with
the thumb. Pushing it forward increases
engine RPM and allowing it to retract
decreases engine RPM.
Throttle Limiter Screw
ATV-0053
Throttle lever travel may be limited by
adjusting the throttle limiter screw. The
throttle limiter should be adjusted
according to the operator’s skill and
experience. To adjust the throttle limiter,
use the following procedure.
1. Loosen the jam nut.
2. Turn the throttle limiter screw clock-
wise to decrease engine RPM maxi-
mum or counterclockwise to
increase engine RPM maximum.
3. Tighten the jam nut securely.
NOTE: The ATV is equipped with
an RPM limiter that retards ignition
timing when maximum RPM is
approached. When the RPM limiter is
activated, it could be misinterpreted
as a high-speed misfire.
Speedometer/LCD
Gauge (Digital)
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12-hour mode; the hour meter indi-
cates the total time the ATV has run
and cannot be reset to zero. To set
the clock, use the following proce-
dure.
TXA023B
A. With the ignition switch ON,
press and release the Set Button
until the Clock is displayed; then
press and hold the Set Button to
activate the set mode (clock dis-
play flashing).
B. Press and release the Set Button
to set minutes or the Mode But-
ton to set hours. Holding the
respective button down will
scroll the display.
NOTE: Clock memory power is
supplied through the 10-amp mem-
ory fuse and verified during gauge
“power-up” and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will “power-
up,” reset, and shut down repeatedly
until clock memory power is
restored. Always check the 10-amp
memory fuse if this gauge condition
is noted.
! WARNING
Never activate the override switch
while the throttle is open as a loss of
control may result. Use caution when
using the override switch as reverse
speed can greatly increase.
