39
Texi 1501 TS Computerized Embroidery Machine Operation Manual
Part 21 Appendix
21. 1 Parameter Table
Parameter Name
Parameter Function
Default
Range
Embroidery Parameters 1
Jump to Trim:
Start trimming or not trimming when there are several
skip stitches.
3
1-9, No
trim
Trim Top Thread
Length:
Lock stitch shall be large when embroidering thin material
0.6mm
0.5-1.0m
m
Length After Trim:
Top thread length after trimming. The larger the figure is,
the longer the residual is.
3
1-7
L.S Times while
Trim:
Lock several stitches in trimming to prevent run out of
thread of embroidery after trimming.
1
1-3
L.S Number after
Trim:
Lock several stitches after trimming to prevent run out.
1
1-3
Moving Frame
After Trim
Move hoop or don’t move after trimming.
Yes
Yes, No
Hook Motor
Speed:
Hook stepper motor speed adjustment. The larger the
value is, the faster the speed is.
5*
1-5
Trim Function;
Use trimming function or not
Yes
Yes, No
Embroidery Parameters 2
Needles in a Head:
Current embroidery machine used needle bar number
N*
1-15
Sequin Needle:
Sequin embroidery uses left side, right side or both left
and right side. If sequin function of mechanical
parameters is shut off, the parameter is invalid.
Close*
Close,
Left,
Right,
LR
Break Thread Up:
Lift landing chassis or not in breakage.
Yes
Yes, No
Needle Of Boring:
Stitch position using boring needle (thread break detection
off)
0
0-N*
Needle Of Cord:
Stitch position using cording embroidery (automatic
deceleration)
0
0-N*
