17
Texi 1501 TS Computerized Embroidery Machine Operation Manual
Backward position: After pressing key, a keyboard pops out. Press number key to
input required backward position in stitch count. Press
key and the hoop is
moved to specified stitches and stopped automatically.
Going forward one color: After pressing
key, the cross section is moved to the
start position of following color and stops automatically.
Backing one color: After pressing
key, the cross section is moved to
start position of previous color and stops automatically.
4.3-9 Embroidery Design Trace Operation
The embroidery Design Trace Operation is use to check the location of the design. After
the embroidery design origin is set, press
key to initialize the trace function. A
pop-up will appear saying “Enter Embroidery Status” press ok. If design location is not in
the place needed, try again until satisfied.
Embroidery Design Trace Contour Operation
After setting start point and tracing the design, a new option will appear on the right side
of the trace icon, press
key and the hoop will start to move slowly, outlining
the design with more precision from start point along the contour (precise range). After
the trace contour is finished, it returns to starting point automatically.
4.3-10 Returning to Embroidery Origin Point after Power Failure
The operation is mainly applied when sudden power failure occurs in embroidering
process and when the hoop appears out of place.
When the hoop type is “Other”, this operation is only valid when absolute origin
of hoop is searched before embroidering.
In operation status, press
key to enter into machine menu interface. Press
key and the system prompts “Press OK to start searching absolute origin”.
Press
key to start searching absolute origin. Then the hoop is moved to
embroidering position before power failure and stops.
