![background image](http://html.mh-extra.com/html/texas-instruments/tida-050043/tida-050043_design-manual_1097054024.webp)
Push
to Insert
P2
P3
P4
Getting Started, Testing Setup, and Test Results
24
TIDUEW7 – May 2020
Copyright © 2020, Texas Instruments Incorporated
Integrated Power Supply Reference Design for NXP i.MX 6ULL
Figure 25. Setting DIP Switch (SW7) for BOOT Mode from Internal Memory
Figure 26. Setting DIP Switch (SW6) for BOOT Config from SD Card
Figure 27. Inserting Coin Cell Battery Into BH1
NOTE:
The voltage of the coin-cell battery (3.0 V nominal) must be above 2.4 V for the supervisor to
allow system power-on. If the coin-cell battery voltage is too low, it must be replaced with a
fresh battery to continue testing.