![background image](http://html.mh-extra.com/html/texas-instruments/tida-050043/tida-050043_design-manual_1097054023.webp)
LCD connector
SD
C
a
rd
co
n
n
e
ct
o
r
C
o
in
-ce
ll
h
o
ld
e
r
Boot Config
switch (SW6)
Bo
o
t
Mo
d
e
sw
it
ch
(
SW
7
)
Getting Started, Testing Setup, and Test Results
23
TIDUEW7 – May 2020
Copyright © 2020, Texas Instruments Incorporated
Integrated Power Supply Reference Design for NXP i.MX 6ULL
shows the bottom side of the fully assembled PCB with labels.
Figure 24. Bottom of TIDA-050043 PCB With Labels
The following is a list of steps that must be followed to set up the hardware of the system.
1. Attach stand-offs to the board with screws inserted in the four holes at the edge of the PCB.
2. Set the BOOT option using SW7/SW6 DIP switches (
and
3. Insert CR2032 coin-cell battery in the holder BH1 (
4. Insert the SD card in J2 connector, if SD Card is used for BOOT (
5. Insert the USB micro-B cable into J8 connector for UART debug in Terminal window (
). Type-
A plug connects to computer USB port
6. Insert the 5-V DC adapter barrel jack into J1 connector to supply power (
). SMI24-5-V-P6
from CUI Inc is the recommended power supply.
7. Set SW1 to the
ON
position.
8. After BOOT is complete, connect the desired peripherals. For example: RJ-45 Ethernet (J3), LCD
screen (J9), USB device (J4, J5, J6, J7).