Version: Leo 18 GT_GB_02-2008
43
/
27
4.4.4. Stabilizing of the machine
The support control can be controlled from the basket or from the ground:
•
Place the machine in horizontal position with the hydraulic control valves
•
Set the selection switch (11) of the control panel to the stabilizing (quick
moving) position.
•
Check the horizontal position of the machine with level which one is placed next
to the hydraulic handling arms
11. Selection switch:
Position of
stabilizing (quick
moving)
water-gauge spirit-
level
hydraulic handling
arms
•
The superstructure will only run if all support senses the bottom pressure. In
case of faulty stabilizing, the red lamp will lights and sound signal will be
audible
WARNING!
If the inclination angle is higher than ±1 degree, probably the machine
tilts or the bottom arm is not able to return to its normal position and the
stabilization is not possible any more, furthermore the machine can be
damaged due to butting on of the cage arm, therefore the machine must
not be operated if the inclination angle is higher than ±1 degree.
The safety direction of the stabilizing
•
Check the free movement of the ground plates whose movement must not be
blocked by any dirt or damages. Tehcnical moving of the support system is 16
mm during stabilizing.
16 mm
•
Monitor the arc movement of the supports that those do not cause personal injure
or damage of the things
•
Check whether the supports bear up to suitable strength soil.
•
In case of not a suitable strength soil, enlarge the surface of the soil with support
plates
•
Check whether the caterpillar tracks are in uplifted position in stabilized position of
the machine.
