Version: Leo 18 GT_GB_02-2008
43
/
31
Sequential contol of the
bottom
arm and the bottom telescope
shall be executed with special
care:
-
First the bottom telescope
should be retracted totally.
-
Secondly the bottom arm
should be moved
downwards!
1.
2.
FIGYELEM!
BORULÁSVESZÉLY!
Az alsókar lefelé mozgatása csak
a teleszkóp alaphelyzetbe való
behúzása után megengedett!!!
Fordított sorrendben való vezérlés
a gép felborulásához vezethet!
Location of the valves:
10. Cross valve (C)
7a. Vertical arm-in
(down)
1b. Basket
levelling- out
5a. Bottom arm-
down
2a. Upper
telescope-out
1a. Basket
levelling-in
3a. Upper arm-up
2b. Upper
telescope-in
4a. Bottom
telescope-out
3b. Upper arm-
down
6a. Turning left
4b. Bottom
telescope-in
6b. Turning right
9. Proportional
valve
5b. Bottom arm-up
7b. Vertical arm-out
(up)
8. Cross valve (B) 8. Cross valve (A)
4.4.7 Working on the slope
After the adjusting of the water level, on the slope the operator can work safely with the
machine. The lever is next to the hand control valves of the supports. There is not
installed extra leaning detector on the machine.
If the machine cannot be adjusted with the hydraulic support to water level because of
the soil roughness or angle of the slope which one can be maximum 10%in that case you
must put adequate strength and surface backings under the supports.
WARNING
OVERTURING DANGER!
Pushing down the bottom arm is
only allowed after pulling the
telescope in its basic position
Backward sequence of the
above steps can result
overturning of the machine.
