MSR05-20200701
19
CAUTION
The “rounded lower suspension arms “(n°20, figure 2) can be used with the
Dualski and Uniski low parts.
The “straight lower suspension arms”
must only be used
with the Uniski low
part
.
The
Amin
configuration is strongly recommended for the Dualski use (See page 29).
5.3.4 Replacing the « straight lower suspension arms » by the « rounded
lower suspension arms » according to figure 3
Dismounting of the straight lower suspension arms :
Put the Scarver upside down, the lower part side up.
On the aluminium base, (n°5, figure 1) dismount the hexagon head screw 10x65 (40) + 1
lock nut (42) + 2 fender washers (44) + 2 conical spring washers (43). Let the inside ring
(41) in its place.
Dismount the arms on the frame with 2 spanners of 13.
Re-mounting the rounded lower suspension arms :
Take the 2 ribbed inside rings on the straight suspension arms and put them on the
rounded arms. Be careful to place them in the right direction, the larger part against the
frame.
Re-mount the hexagon head screw 8x60 and be careful to replace the washers in the
right position (see Figure 7 p 28). Clamp correctly (22Nm).
Re-mount the hexagon head screw 10x65 and
be careful with the position of the
washers
(see figure 4). The serration of the washers on the screw or nut side. Clamp
correctly (44Nm).
Be careful that the inner ring (41) is in its place.
CAUTION
The
Amin
configuration is strongly recommended for the use of the Dualski.
See explanation page 30.
TH 10x65
2x17
44
TH 8x60
2x13
22
Figure 3
: Lower Dualski base from the front
