MSR05-20200701
18
5.3.1 Explanation on the edging system
On the Dualski, the inclination angle of the skis is different from the inclination angle of the
seat, depending on the chosen configuration:
P
,
P+
,
C
or
C+
.
These 4 configurations correspond to the 4 possible positions of the position indicator of the
edge-adjustment plates (27). For instance, for the P configuration, the indicators are position
on the outer holes. It is essential to have the same settings on both sides according to Figure
3 p 17.
Choice of the setting:
P = Performing.
Of all 4 settings, this is the smallest inclination angle of the skis. With this
setting, the Dualski is easy but still performing.
This configuration is recommended for skiers
who want to perform sliding turns and to side-slip easily or for skiers who have a high spinal
cord injury.
C+ = Carving extreme.
This configuration allows a very important edging and is reserved to
very good skiers. With this configuration it becomes harder to make the Dualski side-slip.
Between these 2 extremities, you can also choose the settings P+ or C.
No matter the chosen configuration, the edging is maximized. The maximum edging angles
of the different configurations are:
P= 57° P+ = 58.5°
C = 60°
C+ = 61.5°
5.3.2 Changing the edging system configuration
CAUTION
Do not touch and change
the setting of the transmitter rods (26) of the
inclination system of the skis. This setting is precise in order to obtain a good
operation.
It is recommended to replace one side first, then the other.
Unscrew a few turns the
“lock nut” of diameter 8 mm on points (31)
Position the indicator of the edge-adjustment plates on the hole corresponding to the
chosen configuration according to Figure 3 p 17. Make sure there is no snow or ice
between the parts.
Retighten
properly
the nut (with a dynamometric spanner, the clamping torque is 22
Nm). If the Nylon ring of the nut is damaged, it needs to be replaced.
Make the same operation for the other side, according to Figure 3 p 17.
CAUTION
The clamping unit of the edge-adjustment plate is subjected to vibrations and
considerable strains. It is essential to tighten the screw properly and to place
the washer in its right location
.
5.3.3 Replacing the Uniski/ Dualski part
Put the Scarver upside down, the lower part side up.
Unscrew the 2 nuts (n°30, figure 2) with a spanner of 18 or 19 (depending of the
nuts).
Install the Dualski low part, watching carefully that there is no snow or ice between
the 2 parts.
Put back the nuts and clamp those correctly (60Nm).
To put back the low Uniski part, make the opposite operation and adjust the centre of
gravity as you like.
