MSR05-20200701
15
5.2 Leg protections
A - Mounting the rear part
“M, L, or XL” or “Racing”
A1
– Adjust the sitting angle of the frame (see page 30).
A2
– Once the skier is installed in the seat with his feet in the rear part,
visualise the good height of it and mark the corresponding pre-marked
holes to drill. The height is correct when there is enough space for one
finger between the foam and the thigh at the front of the seat.
A3
– Drill the 4 visualised holes, with a diameter 7mm drill.
A4
– Mount the rear part with the four large washers and the four 6x16
hexagonal head screws diameter 6 included with the footrest. Be careful
to screw it with your fingers at the beginning in order not to damage the
tapping of the frame. (Final clamping 0.8 Nm)
IMPORTANT
With the
Dualski
, do not use the highest fixing
points because the inner ski would hit the footrest
when leaning to the maximum with the shock
absorber compressed. This comment is valid with
the wide and Racing footrests.
B - Mounting the front parts
(“Racing”)
B1
– When the skier is sit in the seat with his feet in the rear part adjust the front part on it
and fastens it moderately with the Velcro.
B2
– Adjust the knee part and visualise on the front part the good holes to drill. When you
visualise the correct hole to drill, make sure that the two parts are well linked, one on the
other. Also make sure that the rear part matches perfectly on the front feet area.
B3
– Drill the front visualised point (at the centre of the cover) on the front part with a
diameter 5mm drill.
Racing rear
part
Front
lower
part
Front upper part
« Wide » rear part (M, L
or XL to use with fabric
cover)
