Terex Genie Z-45 XC, Service And Repair Manual

Page: 116 / 197

Service and Repair Manual November 2020
Deutz TD 2.2 L3 Engine Fault Codes
104 Z
®
-45 XC
™ • Z
®
-45 HF Part No. 1268197GT
DTC = Diagnostic Trouble Code
FMI = Failure Mode Identifier
SPN = Suspect Parameter Number
DTC SPN FMI Description
877 5441 2 Engine fuel injection timing error
for multiple cylinders.
878 5357 2 Engine fuel injection error for
multiple cylinders. Diagnostic
fault check to report the error
due to non plausibility in ZFC.
879 523612 12 Internal recovery. Diagnosis fault
check to report the error to
demand for an ICO due to an
error in the PoI2 shut-off.
88 598 10 Clutch switch. Abnormal rate of
change.
880 523612 12 Internal recovery. Diagnosis fault
check to report the error to
demand for an ICO due to an
error in the PoI3 efficiency factor.
881 523612 12 Internal recovery. Diagnosis fault
check to report the error to
demand for an ICO due to an
error in change of EOM.
882 5357 2 Engine fuel injection error for
multiple cylinders. Diagnosis
fault check to report the error to
demand for an ICO due to an
error in total torque relevant
quantity.
883 5357 2 Engine fuel injection error for
multiple cylinders. Diagnostic
fault check to report the error
due to injection quantity
correction.
884 5442 2 Engine fuel injection pressure
error for multiple cylinders.
885 29 2 Accelerator pedal 2 position.
886 677 2 Engine starter motor relay.
Function monitoring: Fault of
ECU power train active.
DTC SPN FMI Description
887 513 2 Actual engine percent torque.
DFC to report the fault in
energizing time comparison.
888 513 2 Actual engine percent torque.
DFC to report in torque
comparison error.
889 520250 2 Function monitoring: Error in the
post-build selectable monitoring.
890 629 12 ECU. Status of the EMM alarm
FCCU0 which is read out of the
FCCU hardware module.
91 1109 2 Engine protection system
approaching shutdown. Engine
shut off demand ignored.
92 1109 14 Engine protection system
approaching shutdown. Shut off
request from supervisory
monitoring function.
996 629 12 ECU. Diagnostic fault check to
report ABE active state.
997 629 12 Function monitoring: Fault of
ECU, WDA active by
inquiry/response communication.
998 629 12 Function monitoring: Fault of
ECU, Error Pin active suspision
of HW fault.
999 629 12 Function monitoring: Fault of
ECU, WDA active by overvoltage
detection.
The following DTC fault code range shares the same
description. Replace the ECU.
DTC
891 - 945 Description
SPN 629 Internal ECU error.
FMI 12