Terex Genie Z-45 XC, Service And Repair Manual

Page: 34 / 197

Service and Repair Manual November 2020
Platform Controls
22 Z
®
-45 XC
™ • Z
®
-45 HF Part No. 1268197GT
8 Start the engine from the platform controls
and press down the foot switch.
9 Start a timer and simultaneously move the
joystick in either direction full stroke. Note
how long it takes the function to reach
maximum speed. This is the ramp rate.
10 Compare the function ramp rate time with the
table below and determine whether the ramp
rate time needs to increase or decrease.
11 While the joystick is activated, set the ramp
rate. Momentarily move the drive enable
toggle switch in the right direction to increase
the time or momentarily move the drive
enable toggle switch in the left direction to
decrease the time.
Note: Each time the drive enable toggle switch is
momentarily moved, the time will change in 10%
increments.
12 Repeat steps 9 through 11 for each joystick
controlled machine function.
13 Return the joystick to the neutral position and
wait for approximately 10 seconds to allow the
settings to be saved.
Result: The alarm should sound indicating
that the settings have been saved in memory.
Note: Do not operate any machine function during
the 10 second waiting time.
Ramp rate (factory settings)
Primary boom up/down
accelerate 4 seconds
decelerate 0.5 second
Secondary boom up/down
accelerate 2 seconds
decelerate 0.5 second
Turntable rotate
accelerate 2 seconds
decelerate 0.5 second
Drive
accelerate 3 seconds
decelerate to neutral 0.5 second
decelerate, change of direction 0.5 second
decelerate, coasting 0.75 second
decelerate, braking 1 second
decelerate, shift from low to high
speed 1 seconds
decelerate, shift from high to low
speed 2 seconds