Terex Genie Z-45/25J Bi-Energy, Operator'S Manual

Page: 43 / 69

Eighth Edition • First Printing
Operator's Manual
Inspections
Part No. 1311642GT Z
®
-45/25J 41
Test the Oscillating Axle (if equipped)
71 Start the engine from the platform controls.
72 Drive the right steer tire up onto a 6 in/15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
73 Drive the left steer tire up onto a 6 in/15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
74 Drive both steer tires up onto a 6 in/15 cm
block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Test Auxiliary Controls
75 Shut the engine off.
76 Pull out the red Emergency Stop button to the
on position.
77 Press down the foot switch.
78 Simultaneously hold the auxiliary
power switch on and activate each
boom function toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom functions should operate.
Drive functions should not operate with
auxiliary power.
Test Aircraft Protection Package
(if equipped)
Note: Two people may be required to perform this
test.
79 Extend the primary boom approximately
1 ft/30 cm.
80 Move the yellow bumper at the bottom of the
platform 4 inches/10 cm in any direction.
81 Activate each function control handle or toggle
switch.
Result: No boom and steer functions should
operate.
82 Move and hold the aircraft
protection override switch.
83 Activate each function control handle or toggle
switch.
Result: All boom and steer functions should
operate.