Terex Genie Z-45/25J Bi-Energy, Operator'S Manual

Page: 28 / 69

Operator's Manual
Eighth Edition • First Printing
Controls
26 Z
®
-45/25J Part No. 1311642GT
1 LCD readout screen
Screen displays hour meter, voltage, oil
pressure and coolant temperature. Screen
also displays fault codes and other service
information.
2 Engine start switch
Move the engine start switch to either side to
start the engine.
3 Not used
4 Not used
5 Engine idle (rpm) select switch
Move the engine idle select switch to the turtle
position for foot switch activated low idle.
Move the engine idle select switch to the rabbit
position for foot switch activated high idle.
6 Not used
7 Turntable rotate switch
Move the turntable rotate switch to the right
and the turntable will rotate to the right. Move
the turntable rotate switch to the left and the
turntable will rotate to the left.
8 Auxiliary power switch
Use auxiliary power if the primary power
source (engine) fails.
Simultaneously hold the auxiliary power switch
to either side and activate the desired function.
9 Platform rotate switch
Move the platform rotate switch to the right
and the platform will rotate to the right. Move
the platform rotate switch to the left and the
platform will rotate to the left.
10 Platform level switch
Move the platform level switch up and the level
of the platform will raise. Move the platform
level switch down and the level of the platform
will lower.
11 Platform overload indicator light
12 Light flashing indicates the platform is
overloaded. The engine will stop and no
functions will operate. Remove weight until the
light goes off and then restart the engine.
13 Function enable button
Press and hold the function enable button to
enable the functions on the ground control
panel to operate.
14 Jib boom up/down switch
Move the jib boom switch up and the jib boom
will raise. Move the jib boom switch down and
the jib boom will lower.
15 Primary boom extend/retract switch
Move the primary boom extend/retract switch
to the right and the primary boom will retract.
Move the boom extend/retract switch to the left
and the primary boom will extend.