Terex ASV SR70, Service & Repair Manual

Page: 66 / 141

29. Make sure there is nothing that would visibly pre-
vent the reservoir from being removed or is still
attached to other components within the machine,
then proceed.
30. Use a long pry bar to pry the tank upward and
rearward from the front as shown. (fig. 9-31)
Note: You may need to pry the tank upwards within
the chassis from the rear if it isn’t already to prepare
the tank to be moved in step 30.
31. Once the tank is over the axle mounts lift and
remove it from the chassis as shown. (fig. 9-32, 9-
33, 9-34)
Installation
1. To install the hydraulic reservoir, reverse the
removal procedure.
Note: The only service issue warranting the removal of
the reservoir is hydraulic system contamination. Upon
installation, the tank must be clean and free of
any dirt
or debris that may contaminate the hydraulic oil. If you
are unable to successfully flush the tank clean of
all
dirt or debris, replace the tank.
9-7
Rubber Track Loader
9. Hydraulic Reservoir
9-31
9-32
9-33
9-34
Pry-bar
Reservoir
https://tractormanualz.com/