TCG140_R1.1 – May 2018
Page 22
In the time when the input is in an alarm state, on „Monitoring page“, the appropriate input
will be colored in red.
There are two delays - low-to-high and high-to-low for digital input change. These delays are
added to the standard delay of 30mS. They have 0.1-second resolution and by default are
zero.
These options can be used for additional filtering.
On the picture above low-to-high and high-to-low delays are set to 0.1 seconds.
7.2.5.
System
The page for some general settings.
7.2.5.1.
System status
There is information about the general status of the controller here.
The only possible setting here is “Data in roaming” checkbox. By default, it is disabled to avoid
extra charges for data transfer in roaming.
If you are using another operator's card, you must activate “Data in roaming”. Otherwise, you
will not be able to use all GPRS services – emails, HTTP Post, NTP, etc.
7.2.5.2.
GPRS setup
To set the GPRS connection it is necessary to enter the APN (Access Point Name). This setting
can be different for each mobile operator. By default, it is set to “internet”. Some mobile
operators may require also username and password.
7.2.5.3.
General setup
Summary of Contents for TCG140
Page 1: ......
Page 47: ...TCG140_R1 1 May 2018 Page 47 Appendix C Fig 1 Fig 2 ...
