TCG120-4_R1.3
–
May 2022
Page 19
In the time when the input is in an alarm state, on the
„
Monitoring page
“
, the appropriate
input will be colored in red.
There are two delays - low-to-high and high-to-low for digital input change. These delays are
added to the standard delay of 30ms. They have 0.1-second resolution and by default are
zero.
These options can be used for additional filtering.
On the picture above low-to-high and high-to-low delays are set to 0.1 seconds.
7.2.5.
System
The page for some general settings.
7.2.5.1.
System status
There is information about the general status of the module here.
The only possible setting here is the
“Data in roaming” checkbox. By default, it is disabled to
avoid extra charges for data transfer in roaming.
If you are using another operator's card, you must activate “Data in roaming”. Otherwise, you
will not be able to use all data services
–
emails, HTTP Post, NTP, etc.
Summary of Contents for TCG120-4
Page 1: ......
Page 46: ...TCG120 4_R1 3 May 2022 Page 46 Appendix C Fig 1 Fig 2...
