TensCare Uniglo, Instructions For Use Manual

Page: 32 / 170

31
prevent sudden changes if a broken
connection is re-made.
MEMORY
The Uniglo has a Memory with three
functions:
1) Programme Retention. When you
switch the unit on, it will
automatically start in the
programme which was being used
when it was switched off.
2) Usage. Press the phase skip
button and CH2 ▼ together
and hold down for 3 to 5 seconds.
The display will show the number of
times used and duration in hours
used.
Press the same buttons again to
return to normal controls.
3) Memory Reset. To reset memory
to zero, hold down the phase
skip button and CH1 ▼ buttons
together for 3 to 5 seconds.
12. SETTING UP AND USING
UNIGLO
12.1. CHARGING THE BATTERY
The Uniglo is powered by a built-in
rechargeable Li-ion battery. A
charging adapter is included in the
kit. The battery should need
charging about once a month. The
battery should last at least 15 hours
at 50 mA, 300 μs , 50 Hz. To fully
charge the battery it will take about
2 hours.
When the battery is running low, the
low battery warning will show on
the screen. Although the display
fades as the batteries run down, the
strength of the output does not
change until the warning is shown.
Warning: Use only the
charging cable supplied.
Use of other cables could be
hazardous and will negate the
warranty.
To charge the battery:
Connect the charger to the unit and
plug it onto the mains socket.
The battery icon and increasing bar
column will flash on the screen
display – that means the battery is
being charged.
When the battery is charged, the
battery icon will stop flashing, and
remain displayed with a full bar
column.
Number
of uses
Time used
in hours