TensCare Uniglo, Instructions For Use Manual

Page: 31 / 170

30
the strength, press and release the
lower part of the buttons marked
CH1 ▼ and CH2 ▼ .
Caution: should be observed
when using the ALLURA at
high strength settings.
ALLURA has a Yellow LED light on
output socket which means the
output will exceed 10 mA (R.M.S) or
10 V (R.M.S) averaged over any
period of 1 sec. Prolonged use at
high settings may cause muscle
injury or tissue inflammation.
PROGRAMME CONTROL
The button illustrated is the
programme control. The
Uniglo has eight different,
specially developed programmes.
When the unit is first switched on it
automatically enters the
programme FACE 1 .
Each time you press and release the
PROGRAMME CONTROL button, the
programme changes and is shown
on the LCD.
Each time you change the
programme, the strength level
reverts back to zero. This is a safety
feature to alleviate any sudden
feeling of a surge, as each
programme gives a different
sensation.
PHASE SKIP
All the programmes except
FACE 1 and FACE 2 have
seven phases.
The bar column in the middle of the
display increases as each phase
starts:
Phase 1
Phase 2 Phase 3
And so on up to the 7
th
phase (7
bars).
This button can be used to skip a
phase. Press and hold this button for
3 to 5 seconds to skip and go to the
next phase of the selected
treatment session.
LOW BATTERY
An empty battery symbol will
show when you need to
charge the batteries. The unit will
shut down about 2 minutes after this.
KEYPAD LOCK
If you do not press any keys
for 30 seconds, the keypad
will lock so that only the keys marked
CH1 ▼ or CH2 ▼ will work. This is to
avoid accidental changes in
setting. To unlock, press either CH1 ▼
or CH2 ▼ keys.
OPEN CIRCUIT CUTOUT
If the Uniglo is not correctly
connected to your body, the
strength in the channel which is not
properly connected will
automatically reset to zero. This is to