PLDC04348
REVISION 00
November 09, 2020
TECHNICAL OFFICE
November 30, 2020
21
of
58
Reassembly
1
Cut through a Faston clip as illustrated, retaining only the middle part.
2
Join the power lead and the cable of the carbon brush, crimping them with the Faston clip fragment obtained
previously.
3
Locate the carbon brushes in their slots, taking care not to damage the springs.
4
Lock the carbon brushes in position, retracting them fully into the slots so as to facilitate reassembly.
5
Offer the carbon brushes to the rotor and free them from the slots, ensuring that they bear against the rotor.
6
Refit the bearing to the motor shaft and reposition the circlip in its groove.
7
Refit the gear unit to the motor, referring to the witness mark made earlier on the end cap, and turn the shaft of
the gear unit so that it engages with the motor shaft.
8
Proceed with reassembly, repeating the steps of the disassembly sequence in reverse order.
Before refitting the motor to the machine, test it briefly by connecting the leads directly to the
battery terminals.
G
3
4
1
2
7
5
Summary of Contents for NOBLES S6
Page 2: ......
Page 4: ...PLDC04348 REVISION 00 November 09 2020 TECHNICAL OFFICE...
