OPERATION
10
Tennant T3e (09--08)
4. Turn the brush motor hub until the slot with the
spring clip is visible through the scrub head
window (Figure 8).
Spring Clip
FIG. 8
5. Align the pad driver/brush mounting studs into the
motor hub slots and turn the pad driver/brush
counter--clockwise until stud is fully seated in
spring clip (Figure 9). If necessary, press down on
the motor hub lock pin to lock motor hub in place
(Figure 10).
Spring Clip
Pad Driver/Brush
Mounting Stud
Motor Hub
Slot
FIG. 9
6. To remove the pad driver/ brush, press down on
the motor hub lock pin and turn the pad
driver/brush clockwise (Figure 10).
Lock Pin
FIG. 10
INSTALLING FaST--PAK CARTON (FaST Model)
ATTENTION: The FaST--PAK Concentrate Formula
is specifically designed for the FaST system.
NEVER use a substitute, machine damage may
result.
1. Remove the perforated knock-out from the
FaST--PAK carton. Do not remove the bag from the
carton. Pull the hose connector through the
knock--out and remove the orange cap
(Figure 11).
FOR SAFETY: When using machine, always follow
the handling instructions on chemical container.
FIG. 11
2. Lift the recovery tank to access the FaST--PAK
compartment. Connect the supply hose to the
FaST--PAK and place carton into the compartment
as shown (Figure 12). Make sure that the supply
hose doesn’t get kinked or pinched.
NOTE:
If any dried concentrate is visible on the supply
hose connector or on the FaST-- PAK connector, soak
and clean with warm water.
FIG. 12
