Tennant 6200E, Service Manual

Page: 154 / 222

ELECTRICAL
4-34
6200E 330415 (5--99)
12. Remove the four flat head screws holding
the main brush motor to the motor pivot
plate and machine frame.
NOTE: You may have to rotate the brush arm
weldment to line up the access holes.
13. Go under the front of the machine and
locate the main brush motor behind the front
drive assembly. Disconnect the main brush
motor from the main harness.
14. Remove the main brush motor from the
machine.
NOTE: Note the orientation of the motor and
electrical wires.
15. Install the new main brush motor into the
machine.
NOTE: Make sure to orientate the motor so the
wires are pointed to the front of the machine.
16. Connect the new main brush motor to the
main harness.
17. Wire tie the motor wires to the motor
housing.
18. Line up the mount holes in the new motor
with the mount holes in the machine frame
and motor pivot plate. Reinstall the four flat
head screws. Tighten to 11 -- 14 Nm
(7 -- 10 ft lb).
NOTE: You may have to rotate the brush arm
weldment to line up the access holes.