Tennant 275 Series II, Operator'S Manual

Page: 113 / 132

MAINTENANCE
3-53
275 SERIES II MM190 (6---90)
BRUSH DOOR SKIRTS
The brush door skirts are located on the bottom of
each of the two main brush doors. They seal the
main brush compartment. They should clear the floor
up to a maximum of 0.25 in (5 mm).
The skirts should be inspected for wear or damage
and adjustment daily.
TO REPLACE AND ADJUST BRUSH DOOR SKIRTS
1. Park the machine on a smooth, level surface.
2. Stop the engine and set the machine parking
brake.
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, set parking brake,
and turn off machine.
3. Open the main brush doors.
4. Remove the brush door skirt retaining bolts.
A
B
C
00570
BRUSH DOOR SKIRT
A. Brush Door Skirt
B. Skirt Retaining Strip
C. Brush Door
5. Remove the skirt retaining strip and the door
skirt.
6. Position the new door skirt and skirt retaining
strip on the brush door.
7. Thread the skirt retaining bolts through the
brush door, the door skirt, and into the skirt
retaining strip.
NOTE: The brush door skirts have slotted holes to
allow for a ground clearance adjustment. The door
must be closed for proper adjustment.
8. Slide the brush door skirt up or down so that
the skirt clears the floor by 0.25 in (5 mm).
9. Tighten the skirt retaining bolts.
10. Close the brush doors.