MAINTENANCE
3-19
140E MM156 (6--91)
HOPPER SIDE SEALS
A seal is located on each side of the machine
frame to seal the sides of the hopper. The seals
should be checked for wear or damage after
every 80 hours of operation.
TO REPLACE HOPPER SIDE SEALS
1. Place the master power switch in the “off”
position.
WARNING: Brush Throws Debris. Stop Motor
Before Lifting Hopper.
2. Grasp the hopper handles; lift and swing the
hopper up and out of the machine.
3. Remove the two side seal retaining bolts.
A
B
01208
LEFT SIDE DUST SEAL
A. Side Dust Seal
B. Side Dust Skirt
4. Remove the side seal retaining strip and
side seal.
5. Fold new side seal so the mounting holes
line up.
6. Slide the retaining bolts through the retaining
strip, the side seal, and into the machine.
7. Tighten the seal retaining bolts.
REAR BRUSH SKIRT
A dust skirt is located behind the main brush to
control dusting. It should be checked for wear or
damage after every 80 hours of operation.
TO REPLACE REAR BRUSH SKIRT
1. Place the master power switch in the “off”
position.
WARNING: Brush Throws Debris. Stop Motor
Before Lifting Hopper.
2. Remove the debris hopper and battery
cover.
3. Disconnect the batteries-to-machine
connector.
FOR SAFETY: When Servicing Machine;
Disconnect Battery Connections Before
Working On Machine, And Avoid Contact With
Battery Acid.
4. Remove the batteries from the machine.
5. Carefully tip the machine onto its side.
6. Remove the bottom bolts from each of the
rear guide wheel brackets.
7. Remove the single bolt between the two rear
guide wheel brackets.
A
B
01218
REAR BRUSH SKIRT
A. Rear Brush Skirt
B. Brush Baffle
8. Pull the rear brush skirt and brush baffle out
of the machine.
9. Position the new rear skirt and brush baffle
on the machine.
10. Secure the rear skirt and brush baffle to the
machine with the three bolts removed
earlier.
11. Carefully tip the machine back into the
“operating” position.
12. Reinstall the batteries. Reconnect the
batteries-to-machine connector.
13. Replace the debris hopper and battery
cover.
Summary of Contents for 140E
