MAINTENANCE
140E MM156 (6--91)
3-14
SIDE BRUSH
The side brush sweeps debris from walls or curbs
into the path of the main brush. It should be
inspected daily for wear or damage. Remove any
string or wire found tangled on the side brush or
side brush drive hub.
The side brush adjustment should be checked
after every 20 hours of operation. The side brush
is properly adjusted when, with the side brush arm
in the “raised” position, there is approximately
1 in (25 mm) of space between the floor and the
side brush bristles.
Side brush adjustments are made by mounting
the side brush in a different one of the five
mounting holes in the side brush drive shaft.
The side brush should be replaced when the
remaining brush bristle measures 1 in (25 mm) in
length.
TO REMOVE SIDE BRUSH
1. Place the master power switch in the “off”
position.
FOR SAFETY: Before Leaving Or Servicing
Machine; Stop On Level Surface, And Turn Off
Machine And Remove Key.
2. Pull the side brush arm up and back to raise
the side brush.
3. Remove the side brush retaining bolt or hair
cotter pin.
01027
REMOVING SIDE BRUSH RETAINING BOLT
4. Slide the side brush off the side brush drive
shaft.
TO INSTALL SIDE BRUSH
1. Slide the side brush onto the side brush
drive shaft.
2. Fasten the side brush to the shaft with the
retaining bolt or hair cotter pin.
3. Check the side brush adjustment as
described in
TO ADJUST SIDE BRUSH
.
TO ADJUST SIDE BRUSH
1. Place the master power switch in the “off”
position.
FOR SAFETY: Before Leaving Or Servicing
Machine; Stop On Level Surface, And Turn Off
Machine And Remove Key.
2. Pull the side brush arm up and back to put
the side brush in the “raised” position.
3. Remove the side brush retaining bolt or hair
cotter pin.
4. Slide the side brush up or down on the shaft
until there is approximately 1 in (25 mm) of
space between the floor and the side brush
bristles.
01027
ADJUSTING SIDE BRUSH HEIGHT
5. Line up the side brush and drive shaft holes
to allow the side brush to be nearest to the
specified dimension.
6. Secure the side brush to the drive shaft with
the retaining bolt or hair cotter pin.
Summary of Contents for 140E
