Wireless N300 ADSL2+ High Power Modem Router
8
Bridge
When Bridge mode is enabled, this device works as a modem. If you wish to initiate
a dialup directly from your PC for Internet access or enjoy the entire Internet
connection by yourself (instead of sharing it with others), you can select
Bridge
.
Note
If your country and/or your ISP are not covered on the home page, select
Other
country and ISP, and set VCI and VPI
value manually. If you cannot locate this information, refer to
Appendix 4 VPI/VCI List
or
ask your ISP to provide it.
For more information, see
To Set up the ATM interface
and
To Set up WAN Service for ATM Interface
.
3.2.2 Ethernet Mode
1.
Link Type:
Select
ETH
.
2.
Select your
Connection Type
according to your accessing method.
3.
Secure your wireless network. (Strongly Recommended)
4.
Click
OK
to apply your configurations.
Note
After saving the Ethernet mode settings, you will see the following prompt:
And then you need to connect the Ethernet cable from the Internet side provided by your ISP to the LAN/WAN port, i.e.
to finish
Step 3
of Ethernet Mode in
Chapter 2 Hardware Install-> 2.2 Install the Device
.
