Operation
Operating Instructions
HEAD AND FOOT ADJUSTMENTS (A, B)
• Adjusts the Head and Foot sections to the desired
positions. Press until the red LED Signature Light
illuminates and desired position is achieved.
BED “FLAT” BUTTON (C)
• To level the Ergo System to the Flat position,
press until the red LED Signature Light illuminates.
NOTE: The “FLAT” cycle can be interrupted and
cancelled by pressing the head or foot adjustment
buttons (A or B).
MEMORY BUTTONS (D)
• Your GrandBed TEMPUR
®
Advanced Ergo System
™
can
store up to four (4) Memory Positions.
• To Set a Memory Position: When in desired position,
press and hold Memory button until the LED Signature
Light flashes 3 times to signal Memory position is stored.
• To Recall a Memory Position: Press and hold the
corresponding Memory button until the red LED
Signature Light illuminates.* Do not hold for more than
five (5) seconds, otherwise a new Memory position
could be set. If the LED Signature Light begins to flash,
you are reprogramming the Memory position.
HEAD AND FOOT MASSAGE ADJUSTMENTS (E, F)
• Turns on the Head and Foot Massage units
(starting at intensity 1 of 10).
• Slowly increases or decreases Massage Intensity.
To increase Massage Intensity, press the (+) button.
To decrease Massage Intensity, press the (-) button.
MASSAGE STOP (G)
• Press and hold STOP button until the red LED Signature
*NOTE: An unintentional touch to any button that does not illuminate the red LED Signature Light on the
wireless remote control will cause the keys to light up without performing the associated function. Press
the appropriate wireless remote control button until the red LED Signature Light illuminates to activate
the desired function. This feature was included to prevent any undesired movement should the wireless
remote control be dropped, etc.
Light illuminates and the Massage feature stops. The
Massage feature is designed to automatically shut off after
30 minutes of continuous use. The unit will reset after 5
minutes, and the Massage feature will again be available for
use.
• You MUST stop Massage motors each time before
switching between wave speeds/types.
WAVE MASSAGE SPEED ADJUSTMENTS (H)
• If the Massage feature is off, press any Wave Speed
button to initiate the Wave Massage feature. Each button
represents the amount of time the massage spends in
each section (head or foot) before switching. If the Wave
Massage feature is already on, you must first stop the
massage by pressing the STOP button (G), and then press
the desired Wave Speed; otherwise the Wave Massage
feature will not start.
NOTE: If the massage motors are operating and
the “FLAT” button (C) is pressed, the massage
motors will stop operating during the lowering
of the Ergo System. To then resume massage
operation, press the Head and/or Foot Massage
Adjustments (E, F) or select a Wave Speed.
ADDITIONAL WIRELESS REMOTE CONTROL FEATURES
• To aid in the visibility of the Wireless Remote control in low
light environments, the buttons are backlit and will light up
when a button is pressed.
• You are able to control your Ergo System with the Wireless
Remote control without pointing the Wireless Remote
control directly at the receiver (best transmission range is
within 9 feet or 3 meters).
17
Customer Service: 1–800–979–1457
