Installation
STEP 1
Lift carton top off box to reveal the bottom of the base.
STEP 2
Using a power extension cord
*
to reach the base,
plug in the base’s power cord.
NOTE: Do not uncoil the base power cord as
packaged for shipment.
* AN ELECTRICAL SURGE PROTECTION UNIT IS
RECOMMENDED (NOT INCLUDED).
STEP 3
Cut and remove power down box from frame and
install 9-Volt batteries.
STEP 4
Remove the remote control and (4) AAA batteries from
the accessory carton, open the battery door on the
backside of the remote control, and install the batteries.
STEP 5
Power Test Procedure:
Press each of the following buttons long enough to
illuminate the red LED Signature Light on the remote
control, and watch/listen for the base to activate.
This ensures you will be delivering a base that is fully
functional. Test the base by pressing the buttons in
the following sequence:
• Head Lift / Foot Lift / Head Massage / Foot Massage /
Stop / Flat
—
Only press each long enough to see/hear each
motor activate.
NOTE: If the base does not perform properly,
immediately call Tempur-Pedic Customer Service
at 800-979-1457. Be prepared to provide the
service agent with the serial number of the
base, the retailer’s name, and facts about
the situation.
STEP 6
Once the warehouse test is successful and complete:
• Unplug the power extension cord.
• Return the remote control to the accessory carton
(remove batteries).
• Place the lid back on the outer carton and secure
for delivery.
NOTE: Always keep the Ergo base in a flat,
not vertical, position during transportation
and delivery. Always open the box in the flat
position.
NOTE: To avoid damage to the Ergo System,
always open the carton while the bed is in the
flat position.
Pre-Delivery Procedure
PRIOR TO LOADING FOR DELIVERY:
OPEN FLAT
11
Customer Service: 1–800–979–1457
