GrandBed TEMPUR
®
Advanced Ergo System
™
Place Bracket Bolts (H) with a 5/16 inch washer (J)
through the Outer Headboard Bracket (F) and into
the Inner Headboard Bracket (E). Use 5/16 inch
washers (J) and 5/16 inch nuts (K) and hand tighten
to allow for adjustment.
Repeat on the other side.
STEP 1D
Ensure the Headboard Bracket is assembled with a
distance of 1.5 (38.1 mm) to 2 inches (50.8 mm)
between the edge of the Ergo System and the
headboard bracket assemblies.
STEP 2
Attach your headboard to the Headboard Brackets
following the steps below:
STEP 2A
Measure the center-to-center distance of the
mounting holes in your headboard.
STEP 2B
Measure the center-to-center distance of the
mounting holes in the Headboard Bracket Assemblies.
STEP 2C
If the Headboard Brackets require adjustment, loosen
the bolts that are holding the Outer Headboard
Brackets and move them so that the mounting holes
on the Outer Headboard Bracket align with the
mounting holes on your headboard. Reinstall the
bolts on the Outer Headboard Bracket and firmly
tighten.
STEP 2D
Place your headboard bolts through the mounting
holes on both the Outer Headboard Bracket and your
headboard. Firmly tighten.
STEP 3
Place your Tempur-Pedic mattress on top of your Ergo
System Base.
WARNING: Verify the space between the
headboard cross member and the top of the
mattress is no more than 3 inches.
Your GrandBed TEMPUR
®
Advanced Ergo System
™
installation is now complete. Refer to the Wireless Remote
Control Guide on the following pages or the supplied
Quick Reference Guide for additional usage instructions.
14
Customer Service: 1–800–979–1457
