Activating the EDGE W-200 module
Temptime LoRaWan enabled solution
EDGE W-200 module
Page 26
8
Activating the EDGE W-200 module
This section assumes that your EDGE LoRaWAN™ receiver is up and running and within wireless range of
the EDGE W-200 module you are trying to connect.
The EDGE W-200 temperature / humidity module runs on battery power. To activate your EDGE W-200
module and enable it to communicate via your EDGE Gateway receiver and the Cloud, follow these
steps:
1.
Insert the provided battery, if not already installed, making sure to respect the polarity (see
image printed inside battery slot). We recommend that you use a manual screwdriver, being
careful not to over-tighten the screws.
Figure 15 – Remove the back cover and insert battery
2.
Wait during the boot sequence, while the device displays various information, such as the serial
number, etc.
3.
Once the boot is complete, press the pushbutton on the front of the EDGE W-200 module.
4.
If a receiver is within wireless range, the module establishes the wireless connection
automatically and
ACK_Received
is displayed on the screen.
è
5.
See EDGEConnect and EDGEConnect Mobile documentation for more details on activation and
settings.