8
www.templari.com
5 Transport
WARNINGS!
Regardless of the type of transport, must never be inclined more
than 45°. Contrary you can have anomalies in the refrigerant
circuit in the next operation. In severe cases this may have as a
consequence a failure inside.
The transport to the final place of installation should be done on
a pallelt. The heat pump
KITA AIR Templari® can be transported
using a forklift.
KITA AIR
Kg. 260 - 130
•
Protect the sidewalls of the product coming into contact
with the forklift to prevent scratches and damages.
•
Lift the product only from the back and from the side of the
fittings.
•
The lifting of excessive weights can cause spinal injuries, for
example.
•
Consider the weight of the product riported in the technical
data.
•
In the transport of heavy loads, comply with the instructions
and the provisions in force.
•
It is recommended to pay attention do not to overexertion
when lifting the internal unit. It is advisable to be at least in
two persons.
6 Mounting and installation
6.1 Equipment check
•
cable for remote control panel connection
•
sensor probe
optional
•
Anti-vibration mountings for ground fixing;
•
wall support for internal unit.
6.2 External unit measurements
C:
IN
D:
cable passages
A:
condensate drain
B:
OUT
1516
325
1133
325
259
1257
1791
121
122
89
292 352
233 170 231
641
231 170 233
A
B
C
D
6.3 Free spaces for the assembly
Distance
Measures in millimeters
A
>300
B
>2500
C
>500
D
>3000
E
>1000
Respect the minimum distances mentioned above to ensure a
sufficient air flow and facilitate maintenance works.
•
If the product is installed in areas prone to heavy snowfalls,
verify the snow doesn’t accumulate around the product
and the minimum distances mentioned above are
respected. If these conditions can’t be satisfied, install then
an additional heat generator in the heating circuit.
