Cyclone User Manual
11
Mounting Hardware Options
Mounting Bolts
•
Each Enclosure must be mounted with at least FOUR
points (six points if hanging)
•
All mountings must be made using the M12
threaded holes on the top or bottom of the
enclosure.
•
Be sure to use the sealing washers supplied for any
top fixings.
•
Use an 8mm hex key to secure the M12 socket cap
screws provided.
•
Tempest recommends the use of stainless steel
mounting hardware.
•
Make sure the inlet filter has at least 75mm/3in
clearance below.
IMPORTANT SAFETY NOTICE
Installer must ensure that all mounting points are secure
and conform to local safety regulations. Tempest Lighting
Inc. accepts no responsibility for damage or injury arising
from inappropriate or unsafe installation.
Mounting Options
–
Unistrut Kit
If mounting positions for the corner bolts are not
convenient, use the Unistrut Kit (55.UR.xxx) to add two
Unistrut rails to the top or bottom of the enclosure.
Using industry-standard Unistrut hardware, the enclosure
may now be attached at any point along the Unistrut
rails.
Note: Unistrut rails are required for use with the
Cyclovator mount
–
se
e below…
8mm
Mounted from Above:
M12-1.75 bolts
Use 8mm hex key
Sealing washers
Mounted from Below:
M12-1.75 bolts
Use 8mm hex key
Unistrut Rails may be
mounted above or
below
