Cyclone User Manual
13
Cyclovator 2 Tilt Kit
SAFETY WARNING
IT IS A SAFETY REQUIREMENT that Cyclone enclosures
with front or rear slide be horizontal any time you slide
the projector out for service. IT IS DANGEROUS to do this
if the enclosure is not horizontal, and MAY CAUSE
DAMAGE TO THE PROJECTOR OR INFLICT SERIOUS INJURY
TO PERSONNEL. Tempest Lighting Inc., its agents and
employees, will not be liable for consequences of failure
to heed this safety warning.
Cyclovator 2 may be used for any G3 or G4 Cyclone
enclosure.
The enclosure may be installed at ground level, projecting
up (up onto a building, for example)…
…or, on a rooftop,
projecting downwards.
In either case, the maximum tilt angle is 60
°
.
Cyclovator
–
Unistrut Mounting Rails
When Cyclone G4 is used with the Cyclovator Tilt Kit, the
Unistrut Kit (55.UR.xxx) is required to attach the
enclosure to the Cyclovator.
‘xxx’ is the Cyclone model number.
Cyclovator
–
Inlet Cowl
When Cyclone G4 is used with the Cyclovator Tilt Kit, with
a tilt angle greater than 40
°
, use the inlet cowl 55.IC.xx to
protect the inlet filter from weather.
‘xx’ is the
filter size in inches
–
15 for 55.200-350, 22 for
55.400 and up.
Stainless Steel Unistrut
Rail Kit 55.UR.xxx
Inlet Cowl 55.IC.xx
