P a g e
|
32
TEMELSAN MAKİNA SAN. VE TİC. LTD. ŞTİ.
Akçaburgaz Mah. Muhsin Yazıcıoğlu Cad. No:55/1
Esenyurt
/ İstanbul / TÜRKİYE
TEL: +90 (212) 544-2518 FAX: +90 (212) 577-6557 www.temelsan.com [email protected]
MACHINE SERVICE
The machine is almost Service Free; there are just few points to care.
NOT= The devices which is marked with “
*
“ they are the Optional Devices
Device or part
Life
Frequent to change or service
•
*Hydraulic Oil
2000 Hours
Monthly to check the level
Average all 4 years to change
•
Machine inside
twice a year
Open all Doors and plates around the Machines to see inside, use an vacuum cleaner to clean the
machine free from dust. Attention, plug out the machine from Power and Press-Air when you will do
this operation.
After any change of clamping jaws have to be made the calibration procedure with Carbon Papers.
•
Band Alignment Stoppers
Weekly to check and adjust
CLAMPING JAW SERVICING / GRINDING INSTRUCTIONS
The Top-Jaws are Steel and the regrinding period is longer than the Lower-Jaws.
The re-grind able volume is 2 mm, keep 1 mm as last, do not grind down less then this 1 mm.
The Lover-Jaws are a type of Bronze; Temelsan is using the Ampco-Bronze, hard and very high
connectivity. The re-grind able volume is 6 mm, keep 1 mm as last, do not grind down less then this 1
mm.
Grind anytime pair wise, keep the parallelism by less then 2 hundredths mm, Tol: +/- 0.01
The Connectivity is very important, which why it’s forbidden to grease or oil the surface of jaws.
The reasons to regrind the Jaws are the dirty surface which reduce the connectivity and the
mechanically deformation after many clamping and un-clamping.
For Welds out of precision are usually the Jaws and there precision and condition responsible.
After any Change of Jaws, please run the Carbon Paper calibration.
