P a g e
|
30
TEMELSAN MAKİNA SAN. VE TİC. LTD. ŞTİ.
Akçaburgaz Mah. Muhsin Yazıcıoğlu Cad. No:55/1
Esenyurt
/ İstanbul / TÜRKİYE
TEL: +90 (212) 544-2518 FAX: +90 (212) 577-6557 www.temelsan.com [email protected]
WELDING STOP POINT
The welding STOP point is that position when the power for weld flash must be switched OFF.
This position adjust on a manual wheel on left hand side of the Butt-Welding machines for
Band Saw Blades.
The welding STOP point is dependent by Jaw-Weld Spacing (pre-adjustment), by Upset-
Pressure level and by Weld Power. If one of those points will be different or has an
inconsistent flow, than it could be a need to readjust the Welding STOP point.
The consistent flow of POWER, the consistent and the manual adjusted Jaw- spacing are
very important points and needs special view.
You can use the table on below picture for the stop point adjustment. (BURRING SWITCH)
Few well welded Burr Pictures (different Band widths)
