P a g e
|
19
TEMELSAN MAKİNA SAN. VE TİC. LTD. ŞTİ.
Akçaburgaz Mah. Muhsin Yazıcıoğlu Cad. No:55/1
Esenyurt
/ İstanbul / TÜRKİYE
TEL: +90 (212) 544-2518 FAX: +90 (212) 577-6557 www.temelsan.com [email protected]
9.
CLAMPING JAW GRINDING INSTRUCTIONS
The lower jaws (Bronze)
-just to grind on top surface until any crack on weld edge is out
-Both lower jaws have to be same thickness; it's
recommended to grind it together as a pair
The upper jaws (Steel)
-just to grind on bottom surface until any crack on weld edge
is out
-Both upper jaws should have the same thickness
We recommend to grind the surface of jaws frequently, that has the advantage of
-Better power connectivity
-Straight surface
-Higher weld precision
As earlier you take it out to grind, as less material have to be grinded, the life of jaws will
increase.
10. INSTALLATION OF CLAMPING JAWS
Please make sure that the touch points between Jaws and Jaw-blocks are clean and
free from grease.
When you place the Jaw to position it, check if all surface has contact, very clean
between. Do not create the contact by tighten the screws.
When fixing the screws, not too tight please!
11. CLAMPING DEVICE
The clamping devices are Manual system to clamp Metal Band or Band Saw Blade
for butt-welding procedure.
.
