Telwin Doctor Charge, Instructions For The Use

Page: 60 / 164

- 60 -
c) CUSTOMISED PULSE-TRONIC
It is possible to select:
- the
battery construction technology
(fi g. A.11)
choosing between:
“WET, GEL, AGM, PbCa”
- the
charge current
(fi g.A.6) choosing between:
“AUTO” - automatic setting according to battery
conditions;
“BOOST” - rapid charge;
- the
Ah
- customised setting of the battery Ah (fi g.
A.2) using 6 predefi ned values selected using
the “MODE” button (fi g. A.23), adjustable at 5 Ah
intervals using the “VOLT” button (fi g. A.21), and
“FUNCTION” (fi g. A.22).
Ah SETTING - EXAMPLE
15Ah 100Ah 300Ah
►
15Ah 100Ah 300Ah
DISPLAY
80Ah
75Ah
70Ah
. . . . .
. . . . .
100Ah
95Ah
90Ah
Note.
The fi nal charge voltage depends on the
technology of construction of the battery; to avoid
damaging the battery, pay special attention to the
technical specifi cations given by the manufacturer.
Construction
Technology
Final charge voltage
6V 12V 24V
WET 7.7V 15.4V 30.8V
GEL 7.2V 14.4V 28.8V
AGM 7.35V 14.7V 29.4V
PbCa 8V 16V 32V
AUTO 7.2V 14.4V 28.8V
AUTO 7.7V 15.4V 30.8V
The PULSE TRONIC charge process (fi g. A.17)
starts when the display stops fl ashing, each
individual phase is identifi ed on the display (fi g.
A.14) and terminates with the message (fi g. A.2)
“OK”. The battery charge status is displayed
graphically in (fi g. A.5). If the charge process is
not successful, an alarm message appears on
the display (fi g. A.2) (see alarms list). When the
battery is charged, the battery charger switches
automatically to maintenance mode.
END OF CHARGE - EXAMPLE
CHARGE COMBINATION CHART
BATTERY TYPE
(T)
BATTERY CURRENT
(C)
AUTO
AUTO
AUTO BOOST
MANUAL “Ah”
AUTO
AUTO
AUTO BOOST
MANUAL “Ah”
WET
GEL
AGM
PbCa
AUTO
AUTO BOOST
MANUAL “Ah”
3.3.2 STORING OPERATION SETTINGS
It is possible to store the last function modes, so
they are immediately available after any switching
ON/OFF.
3.3.2.1 STORING PULSE-TRONIC CHARGE
Storage of voltage and type of battery, charge
mode.
Procedure:
- Check that the charge clamps are not connected
to a battery;
- Connect the power cable to the mains socket;
- Set the desired charge mode;
- Disconnect the power cable from the mains
socket.
3.3.2.2 STORING SUPPLY/DIAGNOSTIC
MODE
Storage of delivered voltage and current.
Procedure:
- Set the chosen mode and adjust the voltage/
current values as required;
- Turn on the lock settings by pressing, at the same
time, both keys “VOLT” (fi g.A.21) and “MODE”
(fi g.A.23) for 3 seconds, on the display (fi g.A.2)
(fi g.A. 4) will appear “LOK on.”