How to Set Caller ID Mode
If the phone connected to the SX4e is caller ID-enabled, you can set the SX4e to display the caller
number or name on the phone. Use the following key sequence to set Caller ID Mode.
Press:
* *
7 # <caller ID type>
*
Press
*
for a DTMF phone,
#
for a Bellcore phone and
0
to cancel.
How to Set A 1 Minute Alert Beep
A discrete tone may be generated after each minute interval during the call. Use the following key
sequence to set the alert beep.
Press:
* *
8 <alert beep set/cancel>
Press
*
to set a one minute beep and
#
to cancel it.
How to Set the Connecting Tone
A discrete tone may be generated when a call is connected successfully. Use the following key
sequence to set the connecting tone.
Press :
* *
1 <connecting tone set/cancel>
Press
*
to set the connecting tone,
#
to cancel the connecting tone.
How to Reset the Terminal Factory Defaults
Use the following key sequence to reset the the factory defaults.
Press:
* *
4 # <lock code>
*
How to Program Hot Line (Emergency) Settings
You may preset up to three different emergency numbers. Of these three, one may be enabled as
the “hot line” setting, which will dial automatically two seconds after you pick up the handset without
dialing.
How to Input Emergency Phone Numbers
Use the following key sequence to input emergency phone numbers.
Press:
* *
# 7 6 9 3 # <location> <emergency> #
The
<location>
indicates that the phone number is 1, 2, or 3 of a list of three (maximum), and
<emergency>
is the actual phone number.
How to Designate the Hot Line Number
Use the following key sequence to designate which number is the hot line number.
Press:
* *
# 7 6 9 3 # 0 <number> #
1, 2,
or
3
designates a phone number (from a previously input list) as the hot line number and
0
dis-
ables the hot line designation.
PHONECELL SX4e TECHNICIAN PROGRAMMING
Technician Programming Commands
The SX4e can be programmed with an ordinary telephone, which is sometimes referred to as a
POTS (Plain Old Telephone Service) phone.
Note:
Programming mode is not accessible while you’re in a call.
The following section shows you how to program the SX4e. In every case, a confirmation tone is
heard at the end of each step. An error tone will be heard if the step is incorrectly processed, allow-
ing you to try again. When you press a number to select an item, press
#
to enter it and save the
value. If you press
*
, the value will not be saved. When you press
#
or
*
after the final value, you
will be retuned to the User Programming Menu. To perform any programming, you must first enter
the Technician Mode.
How to Enter Technician Programming Mode
Use the following key sequence to enter Technician Programming Mode.
Press: 47
*
68 # 47
*
869 #
A confirmation tone will sound.
Press:
<security code>
When you enter the six-digit security code
(000000)
, a confirmation tone will be heard. You have
successfully entered Technician Programming Mode and you may proceed with any of the following
commands.
SX4e CDMA 800 • SX4e CDMA 1900
11
Technical Manual