PHONECELL SX4e SET-UP
Phonecell SX4e Set-up Overview
The Phonecell SX4e has several options for unique customer or network applications. These options
are stored in the unit’s non-volatile memory and are retained during power cycling.
In the following sections, an
<entered value>
is comprised of the digits 0 through 9. The digits “
*
”
and “
#
” are considered invalid when used inside an
<entered value>
and will cause that command
to be rejected.
When you enter the set-up mode, a timer is started. If there are no key entries within any 2-
minute period, the SX4e will revert to its normal mode. Going on-hook (hanging up the
phone) will exit the set-up mode
.
Correct entry of the commands below will be confirmed by the return of the programming tone,
which signifies that the unit is ready to accept the next entry. Incorrect entry will result in an error
beep, followed by the return of the unit to standby mode.
How to Adjust Voice Volume
Use the following key sequence to adjust the sound volume of your phone.
Press :
* *
5
Press:
*
(volume up)
or #
(volume down)
NOTE:
Sound volume is automatically set after 3 seconds. You will hear a confirmation beep.
How to Change the Lock Code
The lock code prevents the terminal from being used by unauthorized persons. Use the following
key sequence to display or change the lock code.
Press:
* *
2 # <lock code>
If the Code is correct, it sounds a confirmation beep. If the code is incorrect, the terminal returns to
standby mode with an error beep.
Enter
:
<new lock code>
Repeat:
<new lock code>
The lock code may be any four digit number. When you enter the new code both entries must
match. If they are different, the terminal returns to the standby mode with an error beep. The factory
default lock code is 0000.
How to Restrict Outgoing Calls
Used when you wish to block outgoing calls from being made, but still wish to receive incoming calls
at any time. Use the following key sequence to restrict outgoing calls.
Press:
* *
3 # <lock code>
*
To disable the restriction,
Press:
* *
3 # <lock code> #
How to Set the Alarm
Use the following key sequence to set the alarm.
Press:
* *
6 <alarm time>
*
How to Disable the Alarm
Use the following key sequence to disable the alarm.
Press:
* *
6 #
SX4e CDMA 800 • SX4e CDMA 1900
10
Technical Manual
