26
Over Speeding Scenario
. Helps to inspect the driver and prevent exceeding the fixed speed
limit. The scenario can control DOUT to alert the driver, with, for example, a buzzer or an LED.
Jamming scenario
. Radio jamming is the (usually deliberate) transmission of radio signals
that disrupt communications by decreasing the signal to noise ratio. When jamming detection is
enabled, FMA110 informs (with buzzer or LED, connected to DOUT) driver about jamming event.
Jamming can be deactivated with iButton.
Immobilizer Scenario.
Vehicle can be used only if an iButton is connected and it passes the
security check. The scenario can control DOUT to alert the driver, with, for example, a buzzer or
LED.
iButton list checking
parameter lets the user use this scenario for authorization. The
parameter allows up to 50 unique iButton owners (specified in the iButton list) to be authorized
to use the vehicle.
Note: In order for Immobilizer scenario with enabled
iButton list checking
to
work properly, at least 1 iButton ID must be written to the iButton list.
5.4.2
Trip
Trip customizable feature enables user extended monitoring of performed trips (from
engine start at present location to engine stop at arrived location), log their start and stop points,
view driven total distance
4
. Event will be
generated (included into send records) only
when trip
starts and finishes.
Note: Scenarios and Trip features are activated (DOUTs are activated) only if
configured Ignition Source=1 (ignition is on).
5.4.3
Geofencing
Geofencing is another feature which is highly customizable and can detect wherever car
enters or leaves customized areas. More about Geofencing can be read in 5.14.3 chapter.
Auto Geofencing feature if enabled is activated automatically by turning off car ignition
(configured Ignition Source). Next time before driving user has to disable Auto Geofencing with
iButton or by turning on ignition. In case of theft car leaves Auto Geofencing zone without
authorization FMA120 device automatically sends high priority record to AVL application.
5.4.4
iButton list
iButton list is used to enter authorized iButton ID codes, which are used to authenticate
driver in Immobilizer scenario, Auto Geofencing options and DOUT deactivation in Jamming
scenario.
4
Continuous Trip distance is counted only for ONE trip. If trip is finished (stop point is detected), trip distance
resets to 0 (zero). Next trip will start counting from the begining.